8-channel stereo audio outputs at the same time even if playing 2-channel audio
Used four ESS Tech Sabre premier stereo DACs ES9023
ES9023 delivers jitter-free studio quality audio with 112dB DNR
Each DAC has independent ultra-low-jitter clock generator
Used the Texas Instruments ultra-low-noise voltage regulator
Supports up to 1TB 2.5-inch SATA hard drives
High quality video performance
Supports SPDIF Optical Digital Audio
Supports HDMI high-bit-rate (HBR) audio
4 analog stereo 3.5mm jack outputs
Selected high quality components (Solid Capacitors, Murata MLCC etc)
Allows you to split the audio stream from a HDMI signal
No HDMI output connection is required to receive audio at the analog and optical outputs
Connects directly to the Raspberry Pi - no additional cables needed
Powers the Raspberry Pi - no additional power supply
Lighted power switch
Raspberry Pi status LEDs still visible
Access to Raspberry Pi GPIO
Easy to change the Raspberry Pi OS SD card - No need to open the case
Easy DIY with Raspberry Pi
Power Supply Unit
AC 100 - 240V input ~50 / 60Hz, 5Vdc 4A output
With 2 snap-in plugs for North America (US) and Europe (EU)
DC Power Plug Size : 5.5*2.5mm
Specification
Parameters
Values
Power supply:
+5Vdc +/-5%
Input Ports:
1 x HDMI
Output Ports:
1 x HDMI, 1 x Optical, 4 x 3.5mm Phone Jack
Analog audio output level:
2V RMS
Optical S/PDIF Audio Sampling Rate:
Up to 192 kHz
HDMI Audio Format:
LPCM 8.0CH
Optical Audio Format:
LPCM 2CH, Dolby Digital 2~5.1CH, and DTS 2~5.1CH
Size:
122mm x 90mm x 90mm
Notes
For use with original power supply unit only
WARNING:
DO NOT APPLY POWER TO YOUR RASPBERRY PI VIA THE PI's MICRO USB SOCKET.
Approx. 3 seconds delay to turn on Raspberry Pi after the power button is pressed
(The powerful HDMI audio processing chipset needs time to bootup)
----