Z-0144
Raspberry Pi 3B Overlay Application Kit
This Kit contains a lot of new sensors such as chart below which can support DT (Device Tree) overlay modules in the newest operating system:
| Id | Product Name | Quantity |
|---|---|---|
| 1 | IR receiver | 1 |
| 2 | IR sender | 1 |
| 3 | 0.96-inch OLED display | 1 |
| 4 | 9g Servo | 2 |
| 5 | VGA666 Module | 1 |
| 6 | PCA9685 Servo driver board | 1 |
| 7 | DHT11 temperature and humidity sensor | 1 |
| 8 | USB-GPS module (with wire) | 1 |
| 9 | Bmp180 barometer module | 1 |
| 10 | Breadboard (middle size) | 1 |
| 11 | Buzzer | 1 |
| 12 | RPI B+ T-Cobbler | 1 |
| 13 | GPIO Extend Board | 1 |
| 14 | Acrylic experimental platform (large) | 1 |
| 15 | Exquisite components box | 1 |
Documentation:
| Id | Application Note | Documentation |
|---|---|---|
| 1 | How to use 1 GPIO Pin to drive RaspberryPi Power-on-off-status light | |
| 2 | How to use 1 GPIO Pin to drive RaspberryPi Disk-Status light | |
| 3 | How to use VGA666 module to connect RaspberryPi to display | |
| 4 | How to use BMP180 Barometer to detect pressure | |
| 5 | How to use IR device to remote control alarm buzzer | |
| 6 | How to use enc28j60 network interface card as a GPIO NIC | |
| 7 | How to drive servo by using PCA9685 servo driver board | |
| 8 | How to use RTC module to work as stable clock on RaspberryPi | |
| 9 | How to use LM75 Thermometer module to detect the temperature in the room | |
| 10 | How to use GPS module for real-time location and PPS clock synchronization service | |
| 11 | How to use GPIO drive servo directly | |
| 12 | How to use 0.96 Inch OLED Display to display system information | |
| 13 | How to use DHT11 temperature sensor to detect the temperature in the room |